- Sun Installation and User's Guide GigaSwift Ethernet Adapter

2 Sun GigaSwift Ethernet Adapter Installation and User’s Guide • August 2004

FIGURE 1-1 Sun GigaSwift Ethernet MMF Adapter

LED Displays on the MMF Adapter

Four LEDs are displayed on the front panel of Sun GigaSwift Ethernet MMF adapter.

They are labeled on the front panel as shown in

TABLE 1-1.

Sun GigaSwift Ethernet UTP Adapter

The Sun GigaSwift Ethernet UTP adapter is a low-profile, single-port gigabit

Ethernet copper-based PCI bus card. It can be configured to operate in 10, 100, or

1000 Mbit/sec Ethernet networks. At 10 or 100 Mbit/sec the adapter can be set to

either half or full-duplex. At 1000 Mbit/sec, the adapter must operate at full-duplex.

TABLE 1-1 Front Panel Display LEDs for the MMF Adapter

Label Meaning if Lit Color Source

LINK Link is up. Green* MAC

FDX Link is in full-duplex mode. Green MAC

TX Link is transmitting. Green MAC

RX Link is receiving. Green MAC

*LED will not light until the latest version of the driver software is installed.

FDX

LINK