Storage Subsystems Troubleshooting Guide

138 Sun StorEdge 3900 and 6900 Series Troubleshooting Guide • March 2002
checkt3config Snapshot configuration files are not
present. Unable to check configuration.
Make sure that the snapshot files are
saved and have read permissions in
the /opt/SUNWsecfg/etc/t3name/
directory. If the snapshot files are not
available, , create them by using the
savet3config command.
checkt3mount 1. The $lun status reported a bad or
nonexistent LUN.
2. While checking the configuration
using the showt3 -n command,
operations abort.
Make sure that the requested LUN
exists on the Sun StorEdge T3+ array
by using the showt3 -n command.
Confirm that the Sun StorEdge T3+
array configuration matches standard
configurations.
createvlun Invalid diskpool $diskpool on $vepair,
or diskpool is unavailable.
Ensure the diskpool was created
properly using the showvemap -n
$vepair command. If the diskpool is
unavailable, try creatediskpools -
n $t3name.
If that fails, check the Sun StorEdge
T3+ array for unmounted volumes or
path failures, by using
checkt3config -n $t3name -v.
createvlun Unable to execute command. The
associated Sun StorEdge T3+ array
physical LUN ${t3lun}, for disk pool
${diskpool}, might not be mounted.
Run checkt3mount -n $t3name
-l ALL to see the mount status of the
volume. For further information about
problems with the underlying Sun
StorEdge T3+ array, try
checkt3config -n $t3name -v.
listavailable No Sun StorEdge T3+ arrays are
available. They are either not found, or
the configuration lock is set.
Either the components (the Sun
StorEdge T3+ array, the switch, or the
virtualization engine) are down
(cannot be pinged) or another
SUNWsecfg command is running and
is updating the configuration (ps -ef).
If no other commands are running and
you believe the configuration lock
might be set in error, run the
removelocks command.
modifyt3config The lock file clear waiting period
expired and the creatediskpools
command is aborted.
Check to see if the modifyt3config
and restoret3config commands
are executing on other Sun StorEdge
T3+ arrays. If the commands are
executing, wait for them to complete,
and then run creatediskpools -n
t3name.
TABLE B-3 Sun StorEdge T3+ Array SUNWsecfg Error Messages (Continued)
Message Description and Cause of Error Suggested Action