User's Manual

CPU/MemoryBoardsand Components 3-15
3
3.4.4.1 RemovingaModule
Each module is locked to the main board with a single standoff and is
connected to the main board by two connectors. The pins within the connectors
are compressed to the corresponding board mating surfaces by a metal
compression bar which, when secured with screws, compresses the module
connector pins to the board mating surfaces. See Figure 3-10.
Figure 3-10 Ultra SPARC Module Connector Detail
1. Use the procedures in Section 3.4.1, “Removing a Board,” to remove the
applicable CPU/Memory board.
Warning – The heatsinks on the UltraSPARC modules may be hot. Use caution
when removing or installing UltraSPARC modules and avoid contact.