User's Manual

178 Sun Fire V490 Server Administration Guide • August 2004
5. Type the appropriate command and numbers for the tests you want to run.
For example, to run all available OpenBoot Diagnostics tests, type:
To run a particular test, type:
where
# represents the number of the desired test.
For a list of OpenBoot Diagnostics test commands, see “Interactive OpenBoot
Diagnostics Commands” on page 87. The numbered menu of tests is shown in
FIGURE 6-4.
6. When you are done running OpenBoot Diagnostics tests, exit the test menu. Type:
The ok prompt reappears.
7. Set the auto-boot? diagnostic configuration variable back to true
. Type:
This allows the operating system to resume starting up automatically after future
system resets or power cycles.
What Next
Have a qualified service technician replace the FRU or FRUs indicated by OpenBoot
Diagnostics error messages, if any. For replacement instructions, see:
■ Sun Fire V490 Server Parts Installation and Removal Guide
This document is included on the Sun Fire V490 Documentation CD.
obdiag> test-all
obdiag> test #
obdiag> exit
ok setenv auto-boot? true