User's Manual

Chapter 2 Install Server Module Optional Components 13
Note – For instructions for adding or replacing chassis component filler panels (for
example, network modules or chassis monitoring modules), consult the
documentation supplied with your chassis.
Storage Drive
Module*
*Hard disk drive
or solid state
drive
1. Locate the disk drive filler panel to be
removed from the server.
2. To unlatch the disk drive filler panel,
press the release lever button then tilt
the lever up into the fully opened
position.
3. To remove the filler panel from the
slot, hold the opened release lever and
gently slide the filler panel toward
you.
1. Locate the vacant disk drive module slot in the
server, then ensure that the release lever on the
filler panel is fully opened.
2. Slide the filler panel into the vacant slot by
pressing the middle of the filler panel faceplate
with your thumb or finger.
The release lever will rise as it makes contact
with the chassis. Do not slide the filler panel in
all the way. Leave the filler panel out
approximately 0.25 to 0.50 inch (6 to 12 mm)
from the opening.
3. Using your thumb or finger, press on the
middle of the filler panel faceplate until the
release lever engages with the chassis.
4. Close the release lever until it clicks into place
and is flush with the front of the server.
CPU
Air Baffle
(over empty
CPU socket)
1. Use an Allen wrench (4mm) to loosen
the two mounting screws.
2. Gently pull up the air baffle to expose
the empty CPU socket.
1. Lower the air baffle over the CPU socket, and
align the holes for the mounting screws on the
motherboard.
2. Insert the two mounting screws, then use an
Allen wrench (4mm) to tighten the screws.
TABLE 2-1 Filler Panel Replacement Procedures (Continued)
Filler Panel Module Remove Procedure Install Procedure