User's Manual

34 Sun Blade X6270 Server Module Installation Guide • December 2009
Installing the Server Module Into the
Chassis
Consult the following sections when installing a server module into a powered on
chassis:
■ “Before You Begin” on page 34
■ “Install Server Module Into a Powered-On Chassis” on page 35
Before You Begin
Prior to installing the server module into a powered-on chassis, ensure that the
following requirements are met.
■ Ensure that the following chassis components are installed and powered-on in the
Sun Blade 6000 or 6048 Series Chassis.
■ Chassis monitoring module (CMM).
■ Network express modules (NEMs)
■ All required cabling to the chassis are attached.
■ The system chassis is powered-on.
For information about installing chassis components, attaching cables, and
powering on the chassis, see the Sun Blade 6000 or 6048 Series Chassis
documentation at:
http://docs.sun.com/app/docs/prod/blade.srvr#hic
■ Review the required installation tasks for properly installing and setting up the
Sun Blade X6270 Server Module in the Sun Blade 6000 or 6048 Series Chassis
documentation.
For more information, see
TABLE 1-4.
■ If applicable, install the following optional server module components prior to
installing the server module into the system chassis:
■ FEM, REM, DIMMs, and CPU
For instructions, see
Chapter 2.
■ Use a grounded antistatic wrist strap or equivalent safety equipment to prevent
electrostatic discharge (ESD) when you install the Sun Blade server module into
the system chassis.