User's Manual

Chapter 3 Installing and Powering On the Sun Blade X6270 Server Module 37

Note – The server SP can take several minutes to boot. As the server SP is booting,

the OK/Power LED illuminates a slow blink (0.5 second on, 0.5 second off). After

the server SP boots, the OK/Power LED illuminates a standby blink (0.1 second on,

2.9 seconds off). The standby blink state indicates that the server SP is active and the

server module host (BIOS) is powered off.

FIGURE 3-2 Sun Blade X6270 Server Module Front Panel LEDs

Figure Leg end Server Module LEDs

1 Server Module Locate LED – White

2 Server Module Ready to Remove LED – Blue

3 Server Module Service Action Required LED – Amber

4 Server Module OK/Power LED – Green (blinking or solid state)

5 Server Module Power button/reset

6 Non-Maskable Interrupt (NMI) button (Service only)

7 Universal Connector Port (UCP), used for dongle cable