User's Manual

50 Sun Blade X6270 Server Module Installation Guide • December 2009
2. Verify that an Ethernet cable is connected to the Ethernet port (NET MGT) on
the CMM.
3. If applicable, obtain the MAC address of the server module SP on the cover of
the server module.
4. Log in to ILOM as described in any one these procedures:
■ “Log In to ILOM Using a Serial Connection” on page 47
■ “Log In to ILOM From an Ethernet Connection Using the CLI” on page 48
5. Perform one of the following methods to obtain the DHCP IP address assigned
to the server module SP:
■ ILOM – CMM
To drill down from the CMM and view the dynamic IP address assigned for a
particular server module, type:
-> show /CH/BL0/SP/network
Note – Where BL0 represents the blade installed in slot BL0. To specify the target
blade, you must specify the number of the slot in which the module is installed.
Blade slots range from 0 to 9 on the Sun Blade 6000 Series Chassis and 0 to 11 on the
Sun Blade 6048 Series Chassis.
■ ILOM – Server SP
To view the dynamic IP address assigned to the server module, type:
-> show /SP/network
Configuring a Static Network
If you are planning to assign a static IP address to a server SP or CMM, consult the
following topics:
■ “IP Configuration Task Checklist” on page 46
■ “Logging In to ILOM” on page 47
■ “Assign a Static IP Address to Server Module SP Using the CLI” on page 51
Note – You can assign IP addresses to the server by using the ILOM web interface
or command-line interface (CLI). For instructions on how to assign an IP address
using ILOM’s web interface, see the Sun Integrated Lights Out Manager 2.0 User’s
Guide or the Integrated Lights Out Manager 3.0 Documentation Collection.