User's Manual

64 Sun Blade X6270 Server Module Installation Guide • December 2009
Mirroring the Preinstalled Solaris OS
with Sun StorageTek REM Card
The Sun StorageTek REM card enables you to choose from many RAID
configurations. How you configure your system depends on your system
requirements and the available hard disk drives in the system.
This procedure describes how to mirror the preinstalled Solaris OS. This is the better
option, and all remaining disks (should there be more than two) are incorporated
into a DATA RAID set using the available options as shown in
TABLE 5-3.
You will need the Sun Blade X6270 Server Module Tools & Drivers CD to perform this
procedure.
▼ Create a Mirror Image of the Preinstalled Solaris
OS
Follow these steps to mirror your configured Solaris OS:
1. Using your Solaris server, log in and start Xserver.
This graphical user interface is required for StorageTek Software Management.
2. Make a new directory on your Solaris server, type:
mkdir /StorMan
3. Insert the supplied Tools & Drivers CD, and copy the StorMan.dss application,
located in the /mount-point/RAIDmgmt/StorageTEK/Solaris directory, to
the new directory you created on your Solaris server, for example,
/StorMan.
4. Change the permissions of the new directory and StorMan application, type:
chmod 777 StormMan.pkg
5. Run the following command to install the application:
pkgadd -d StorMan.pkg
6. Choose to install all components when prompted.
7. To run the application, type:
sh /opt/StorMan/StorMan.sh
A split screen appears.