User Manual

IMPORTANT PRODUCT INFORMATION READ IMMEDIATELY
KEEP ORIGINAL PACKAGING – ALL RETURNS NEED TO BE IN THE ORIGINAL PACKAGING
IN ORDER TO AVOID PRODUCT DAMAGE DURING SHIPPING. ANY DAMAGE TO PRODUCTS
NOT IN THEIR ORIGINAL PACKAGING WILL NOT BE COVERED UNDER WARRANTY.
SAFETY FIRST!
FAILURE TO OBSERVE THE FOLLOWING SAFETY WARNINGS MAY RESULT IN SERIOUS INJURY. IN ADDITION, FAILURE TO OBSERVE THESE
SAFETY WARNINGS WILL RESULT IN A WAIVER OF ALL LIABILITIES ON SUNLIGHT SUPPLY
®
, INC. AND WILL VOID ALL WARRANTIES.
WARNING:
• Iftheexteriorofthelampisdamaged,replacelampimmediately.
• Disconnectpowerbeforere-lamping.
• Whenre-lamping,makesurelamphastimetocoolbeforetouching.
• Makesurepowercordandlampcordareconnectedproperly.
• DoNOThangbypowercordorlampcord.
• DoNOTmakecontactwiththeinteriorofthesocketwhilethepowerison.
• DoNOToperatethelightsystemsinwetlocations.
• DoNOTattempttoopen,rewireorrecongureanycomponentsofthelightsystem.Itwillvoidthewarrantyandcouldcauseseriousinjuryordeath.
• Theseproductsoperateatveryhightemperatures.Keepawayfromchildren.
• Donotplugorunplugalampcordwhiletheballastisturnedon.
• Glassbottomlensrequiredinreectorswhenusingmetalhalide(MH)lampsforETLlistingtoapply(xturemustbefullyenclosed).
 Notrequiredwithhighpressuresodium(HPS)lamps.
BULB INFORMATION: Proper Bulb Care
Alwaysunplugyourballastandallowyourlamptocoolbeforechangingoutyourlamp.Lampsshouldbechangedoutabouteveryyearofcontinuoususetomaintain
maximumlumenoutput.Runningalampbeyonditsexpectedlifeisnotrecommendedandcancauselampfailureaswellasashiftintheoutput&colorspectrum.
REFLECTOR SETUP:
1. See(fig. 1a)forattachingthesocketonConeandParabolicreectorswhichdonotincludethesocket.Socketassembliesforthesereectorsaresold
 separately.ChoosefromProductNo.903055or903060(fig. 1b).
2. Somereectorsinclude/acceptglass.Iftheframeisdamagedorglassbreaksitmaybepossibletopurchasedreplacementglassortheglass/frameassemblies
 separately.Typicallypeopleuseglasstocontrolairmovementthroughthereectorduringaircooling.Thisalsoprotects/containstheenvironmentofyourgrow
 area.GlassisnotrequiredwhenusingHPSlampsfortheETLlistingtoapply.ItisrequiredforMHlampsforthislistingtoapply.Theglassinstallationprocess
 willvarybyreectortype.ItisasimpleprocessforallSunSystem
®
reectorsandismanytimesfactoryinstalled.
3. Useaneyeboltorsomeothermeansofsecurelyhangingfromtheceiling.
4. V-Hangersusedtohangthextureareincludedwithmostreectors(fig. 2).
5. SunLifts
®
,#701125,GrowYoYo’s,#710129,SunGrips
®
,#710114(Fig. 3)orjackchain.
 #350205maybeusedtoadjustthehangingheight.
REFLECTOR SETUP
Technical Information Guide
Fig. 1b
Fig. 3
Fig. 1a
Fig. 2