PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS. Read the operating instructions carefully before putting the appliance into operation and keep the instructions, the receipt and, if possible, the box with the internal packing. If you give this appliance to other people, please also pass on the operating instructions. USER MANUAL SYMBOLS Important information for your safety is specially marked.
13. Do not cover the appliance during operation. 14. Do not place the appliance in or under wall cabinets during operation. 15. Before cleaning, storing and adding / removing components, switch off the appliance and unplug it. 16. Do not operate the appliance without supervision. If you should leave the workplace, always unplug the appliance. 17 A CAUTION: Take special care when using the appliance in places where there are children, the disabled or people with reduced physical, sensory or mental abilities.
shock. 34. /\ CAUTION: Fill the water tank only with fresh, potable water. Do not use carbonated water (sparkling mineral water). 35. Ensure that the filter holder is secure and properly locked during operation, since this appliance works under pressure. 36. Do not operate the appliance without any water inside the tank and do not overfill it. The water level must always be between the MIN and MAX points.
FE —— process! 9. Make sure the drip tray and grill are properly positioned. 10. Set the rotary switch dial to “Coffee” position Ji 11. Position the group. Hold the handle of the group, and place the guides in the corresponding recesses of the espresso machine. Pull the group to the right of the espresso machine with the handle, until the handle is at the same point as "LOCK". Make sure the group secures into place.
/\ CAUTION: Do not drink or use this water for any reason! 24. Press the power switch. 25. The appliance Is now ready for operation. TIP: Repeat the procedure 2-3 Mes for good cleaning of the device before the first use. HOW TO USE 1. Ensure that the voltage indicated on the appliance rating label corresponds to the voltage in the mains. 2. Make sure that the appliance only plugs into a properly grounded and properly installed socket. 3. Place the appliance on a flat surface and away from flammable objects.
(warm-up). When the light stops flashing, coffee will start flowing out of the group outputs. (er 10. Once the process is complete, press the power button and remove the device from the power supply. 11. Allow the appliance to cool down well before cleaning it (see section "CLEANING". Follow the steps below to make frothed milk. The frothed milk should be firm enough, creamy, with a viscous texture so that it can be formed with a spoon.
7. The steam generating Indicator light will start flashing quickly and the appliance will enter the steam mode. At first it may take some time to warm up the device. Once the appliance is ready, the appliance will start producing steam. 8. Shake the Jug slightly up and down. Turn the rotary switch to the “Coffee” position when the milk reaches the desired volume (approx. 50%). 1 NOTE: For extra heating of the milk, place the steam nozzle towards the bottom of the jug.
espresso machine. Pull the group to the Hg ht of the espresso machine with the handle, until the handle Is at the same point as "LOCK". Make sure the group secures Into place. 4, Remove the water tank ld by squeezing both ends of the lid and pulling slightly upwards. WARNING: Do not push or pull the lid too hard 5. Fill the water tank with clean, potable water up to the MAX mark (maximum water temperature should not exceed 35 © C). Close the lid. 6. Connect the device to the power supply. 7.
Press the double dose coffee key and the corresponding Indicator light will illuminate. The device will enter power saving mode. DESALINATION Salts endanger the operation of your appliance. Frequent desalination of the device is ry. The frequency of desalination depends on the frequency of use and the hardness of the water (at least after the production of 400 doses of coffee). 1. Insert the group. Hold the handle of the group, and place the guides In the corresponding recesses of the espresso machine.
dn Go CLEANING AND MAINTENANCE Follow these instructions to properly and safely care for your device. 1. Always disconnect the appliance from the power supply before cleaning or assembling and wait until the appliance has cooled down completely. 2. Do not immerse the appliance in water or spill water directly on it as this could result in electric shock or fire. 3. CAUTION The steam nozzle and all metal parts are hot immediately after use| 4, /CAUTION: Do not use wire brushes or other sharp objects. 5.
3. Let kt soak In hot water for a while. This way the milk residue Is removed more easy. “lore the steam pipe with a damp cloth. NOTE: Fill a container with hot water and insert the steam pipe to remove dry residue. 5. After cleaning, replace the cover with the steam nozzle. Place a heat-resistant empty container under the steam nozzle. STORAGE 1. Always unplug the power cord before storing the device. 2. Make sure the appliance is cold and dry before storage. 3.
