User Manual

- 26 -
Click “General” to set the maximum online connection. Under the user
management page, administrator can also see the list of online user.
10. Motion Detection
To set up motion detection, please go to Configuration-Event-Basic
Event-Motion Detection and check “Enable Motion Detection”. Motion detection
is automatically disabled when the camera is set to advanced tracking features.
Below are settings you can adjust to optimize the detection:
[Enable Dynamic Analysis for Motion] The red square represents the detection
zone. When Dynamic Analysis for Motion is set to ON, anything
triggering motion within the red squares will flash with green squares, which
shows the detected objects. This is helpful when you are adjusting the
sensitivity of motion as it reflects how sensitive a motion can be triggered with
the green squares.