User's Manual

5
Using your Control:
1 To turn the control on, simply press the “On/Off” button. The backlit display light will
reset itself by flashing “FF” and then will light showing the previous setting the unit
was set during the last use and will begin to warm.
CAUTION: ALWAYS turn the warming blanket/warming mattress pad “OFF” when
not in use.
2 To turn the warming blanket/warming mattress pad OFF simply press the “On/Off”
button.
CAUTION: Do not plug main power cord into the wall outlet until you have completely set
up your warming blanket per the instructions.
IF YOU DO NOT FOLLOW THIS SEQUENCE, THE WARMING MATTRESS PAS WILL NOT WORK.
• Disconnect power cord from wall before detaching control from warming mattress pad
• Always make sure cords are NOT trapped or pinched between bed slats, mattress,
springs, against wall, foot board or bed frame.
1 Place the warming mattress pad on the bed with the label side facing outward.
2 Plug cord into the module at the bottom of the warming
mattress pad until the plastic hinges click into place.
CAUTION: Cord must be COMPLETELY CONNECTED. A risk of fire
could result from a loose connection.
3 Run the cord under the bed, not between the mattress and box
springs. Avoid any tangling or pinching.
4 For dual control warming mattress pads, place primary control
(label on back of control) on the same side of the bed as the
blanket label side.
5 For single control warming mattress pads, the control can be
placed on either side of the bed.
6 Plug warming mattress pad power cord into a 110-120 volt
wall outlet.
CAUTION: This appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of electrical shock, this plug is intended to fit only one way into an
outlet. If the plug does not fit in the outlet, reverse the plug. Do not attempt to force the plug.
6
2
IMPORTANT
2
Set Up WARMING MATTRESS PAD
O
n
/
O
f
f
O
n
/
O
f
f
O
n
/
O
f
f
O
n
/
O
f
f
1
2
3
4
5
6