User's Manual

Adjusting Zones Individually
1 To adjust any zone individually, press the “Select
Zone” button that corresponds to the zone you
want to adjust. That zone will become outlined
on the display and will be the only zone that
changes when you press the “ + ” and “ – ”
buttons.
2 Press the “ + ” or “ – ” button to adjust the
heat of the selected zone.
3 To change another zone’s setting, repeat Steps
1 & 2.
NOTE: To Change all zones at once turn off the Mattress Pad and turn it back on. Or you can
wait 60 seconds until the zone’s outline disappears, then press the “ + ” or “ – ” button.
Preheating the Mattress Pad
Never get into a cold bed again during the Winter season.
Preheat warms your Mattress Pad before you get in.
To preheat:
Turn Mattress Pad on. Press the “Preheat” button. All
zones will show a “P” while they are preheating unless a
zone is turned off.
The zones will heat for 30 minutes and then return to
their previously programmed heat settings.
NOTE: Zones with no heat setting (-) will not preheat.
NOTE: To cancel preheat after activating it, press the “Preheat”
button again. The Mattress Pad’s regular heat settings will resume.
NOTE: At least one zone must be selected for the preheat function
to work.
OPERATING INSTRUCTIONS
Turning the Mattress Pad ON and OFF
Turn on the Mattress Pad on or off by pressing the “On/Off” button on the
remote control. When on, the base unit will beep once, the display will light
up, and all zones will appear outlined.
NOTE: The backlight turns off after one minute to save battery power, but the Mattress Pad
remains on. To turn the backlight on again, touch any button on the control other than the
“On/Off” buttons.
Your customized heat settings are stored in memory so the next time you turn
it on, the Mattress Pad returns to the same preferences as the last session.
CAUTION: Always turn the Mattress Pad “Off” when not in use.
Adjusting the
Blue Zones at Once
Your Mattress Pad features 10
adjustable heat levels per zone that
can be increased or decreased
together or separately.
To adjust all the zones up or down
from their current settings, press the
“ + ” button to increase or the “ – ”
button to decrease the heat. All the
zones will change together in the
same increments.
The display shows each zone’s heat
setting: 1 through 9, and then H,
which is the warmest setting. A “ – ”
on the display indicates that the zone
will not heat.
OPERATING INSTRUCTIONS
For questions or support,
please visit:
www
.sunbeam.com
87 For questions or support,
please visit:
www
.sunbeam.com
Selected zone will
appear outlined
Highest Heat
Heat is Turned Off