user manual

4
Important: Always ensure your blender is
unplugged from the power outlet before
fitting or removing the blade assembly.
Always handle the blade assembly with
caution, as the blades are extremely sharp.
To assemble the six-blade system in the glass
jug (see Figure 1).
1. Place the silicone rubber seal over the six-
blade assembly, as shown in figure 1.
2. Place the six-blade assembly into the
glass jug and turn clockwise to secure
firmly into position (see Figure 2).
Note: The blender jug will leak if the six-
blade system is not assembled correctly.
Note: Do not attempt to remove the
stainless steel blades from the blade
assembly.
3. Plug the power cord into a 230-240 volt
power outlet and turn the power ‘ON’.
Before using your MultiBlender
Electronic
500
250
1
2
500
250
1
2
Figure 1
Figure 2
Six-blade
assembly
Silicone
seal