Euro Plus 2400W Convection Panel Heater Instruction Booklet HE4900 Please read these instructions carefully and retain for future reference.
Contents Sunbeam’s Safety Precautions 1 Safety Precautions for your heater 2 Sunbeam’s Total Safety System 3 Features of your Euro Plus Convection Panel Heater 4 Wall mounting your heater 6 Attaching the wheels 7 Using your heater 8 Restricting the temperature range 8 Resetting the safety auto shut off 9 Care and cleaning 9
Sunbeam’s Safety Precautions Sunbeam are very safety conscious when designing and manufacturing consumer products, but it is essential that the product user also exercise care when using an electrical appliance. Listed below are precautions which are essential for the safe use of an electrical appliance: • Read carefully and save all the instructions provided with an appliance. • Always turn the power off at the power outlet before you insert or remove a plug.
Sunbeam’s Safety Precautions • This heater becomes hot during use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (90cm) away from the front of the heater and keep them away from the sides and rear. • Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left unattended.
Features of your Euro Plus heater Patented SCHWARZ element The patented heating element is designed to heat faster than conventional elements. Its single metal construction ensures optimum heat transfer from the element into the surrounding air, to warm the room faster. Overheat protection The safety auto shut off system detects any abnormally high temperatures within the heater and automatically switches it off to prevent overheating.
Thermostat dial The thermostat dial allows you to set your desired temperature level. Accurate to within 1°C, the electromechanical thermostat monitors the room’s temperature and continuously adjusts the heat output to maintain your selected comfort level. The element is only powered for as long as necessary to restore the selected temperature, ensuring maximum efficiency. On/off switch The on/off switch at the side of the unit control’s the heater’s operation.
Wall mounting your heater Before using your Euro Plus heater ensure it is securely mounted on a wall. Wall mounting For maximum efficiency this heater should be positioned so that the heat generated mixes with the maximum volume of air. It can be installed in any room of the home, including the bathroom, in accordance with the instructions below. A A = 10 cm B = 10 cm C = 75 cm 1.
Wall mounting your heater (continued) 3. Mark the first top screw location on the wall, at least 630mm from the floor or skirting board. The base of the heater must be at least 200mm from the floor to ensure adequate air flow into the air inlet. Drill the first hole using a suitable drill bit. 7. To place the heater on the bracket, insert the lower clips first then the top, and push firmly until it clicks into position, as shown in figure 5. 4.
Using your heater 1. Install the heater in accordance with the instructions above. 5. Adjust the thermostat dial to your desired heat level, from 1 to 12. 2. Insert the plug into a 230-240V power outlet and turn the power on. 6. Once the selected temperature is reached, the electromechanical thermostat will constantly monitor the room temperature and adjust the heat output to maintain it. 3. Ensure that the air inlet vent on the underside of the heater and the air outlet are clear of obstructions. 4.
Resetting the safety auto shut off The safety auto shut off detects any abnormally high temperatures within the heater and shuts it off to prevent overheating. Should the safety auto shut off activate and switch off the heater, it will need to be reset. 2.Unplug the heater and wait 5-10 minutes for the unit to cool down. 3.After 5-10 minutes, plug the heater in again and operate as usual. 1.To reset the heater, move the on/off switch to the OFF position.
Consumer Hotline Australia 1800 025 059 New Zealand (09) 912 0747 www.sunbeam.com.au Consumer information: 1800 025 059 or www.sunbeam.com.au is a registered Trademark of Sunbeam Corporation Limited. ACN 000 006 771. © Sunbeam Corporation Limited 2002.
