advanced bark control collar ULTRASONIC INSTRUCTION Manual
IMPORTANT SAFEGUARDS • This device should only be used for bark deterrent training of dogs. • This device is not a toy; keep out of reach of children. • This device is not intended to provide protection against aggressive dogs. • Your dog should be in good health when using this product. • This product is not to be used on dogs less than 9 lbs. • This product is not to be used on dogs less than 6 months old. • Your dog should not be left unattended with this collar on.
DO NOT USE THIS BARK CONTROL COLLAR UNTIL YOU HAVE READ THESE INSTRUCTIONS Product Overview: MAIN CONTROL BUTTON: INDICATOR LIGHTS: • Low • Med • High Solid Green: Correction level selected and functioning properly • On/Off • Correction level adjustment • System reset Flashing Green: Bark detected and correction administered All 3 Flashing Red for two minutes: Over Correction Mode (on selected level LED only) SENSOR PROBE: Used to detect barking All 3 Flashing Red 5 times: Low battery BATTERY DOOR: L
How it Works: The Sunbeam® Advanced Bark Control Collar has a proprietary bark detection system that uses sensors and a voice mapping system to determine barking behavior. This specially designed system ensures that a correction is administered only when unwanted barking behavior is occurring. The system also has been designed to prevent continuous corrections if excessive barking is detected. OVER CORRECTION MODE causes the system to turn off and automatically reset.
COLLAR FITTING Proper fit of the Sunbeam® Advanced Bark Control Collar is essential to establish a good training foundation and optimal performance. Note: Batteries should be installed properly and collar in OFF position before proceeding figure 4 with fitting the collar to your dog. STEP 1: Ensure dog is in a relaxed position. STEP 2: With the collar clasp open loosen the adjustment buckle such that it can reach completely around your dog’s neck. (fig. 4) Place sensors directly over the dog’s voicebox.
READY TO USE Note: The BATTERY INSTALLATION and COLLAR FITTING steps must be completed before you are ready to use. STEP 1: Holding the main body of the Sunbeam® Advanced Bark Control Collar in both hands PRESS and HOLD the Main Control Button for 4 seconds. Note: You will hear 1 audible beep and 3 LEDs flash green indicating the device is on. The default correction level is LOW; this setting will illuminate green for 10 seconds and then automatically turn off.
level setting and will resume this mode when the unit is turned on. The LED of the setting chosen will illuminate GREEN when a bark has been detected and a correction is being administered. OVER CORRECTION MODE: If excessive barking is detected the bark control system will enter a mode designed to shut down the system. The LED of the selected level will illuminate RED and the collar will automatically reset. You can manually reset the system by pressing and holding the Main Control Button.
HINTS AND TIPS Is this product right for me and my dog? • The Sunbeam® Advanced Bark Control Collar is best used in conjunction with behavior training from a qualified behaviorist or obedience trainer. • Before using the bark control collar on an aggressive or phobic dog, consult a qualified behaviorist or obedience trainer. • If your dog begins to display aggressive behavior during or after using the bark collar, discontinue use immediately and consult a qualified obedience trainer or behaviorist.
harmful interference in a residential installation. The product generated, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation.
contrary to the operating instructions, disassembly, repair or alteration by anyone other than JCS or an authorized Sunbeam® service center. Further, the warranty does not cover: Acts of God, such as fire, flood, hurricanes and tornadoes. What are the limits on Sunbeam’s Liability? JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or condition.