Owner's Manual

7
COLLAR FITTING
gure 7
gure 8
gure 9
PropertoftheSunbeam®ReceiverCollarisessentialtoestablish
agoodtrainingfoundationandoptimalperformance.
NOTE: Batteries should be installed properly and the
Receiver Collar should be in the OFF position before
proceeding with tting the collar to your dog.
STEP 1:Ensuredogisinarelaxedposition.
STEP 2:Withthecollarclaspopenloosentheadjustmentbuckle
suchthatitcanreachcompletelyaroundyourdog’sneck.(g.7)
Whenbuckled,thecollarshouldrestdirectlybehindthedog’s
ears(thehighestpartoftheneck).(g.8)
NOTE: Make sure both stainless steel probes go through the
coat completely and make contact with the skin.
Usethelongerstainlesssteelprobesifthecoatdoesnotallow
theshorterprobestoreachtheskin.
Beforechangingthestainlesssteelprobesyoumustcompletely
dischargetheReceiverCollar.BesuretheunitisintheOFF
positionandplacethemetalportionofaplastichandle
screwdriveracrossbothstainlesssteelprobesfor5seconds.
Trimmingthehairaroundthedog’sneckwherethestainlesssteel
probeswilltouchtheskinisoptional,DONOTtrimthehairso
shortthattheskiniscompletelyexposedasthismightallowfor
anirritationorrashtooccur.
Useawrenchwhenassemblingordisassemblingthestainless
steelprobes,donotovertighten.(g.9)
STEP 3:Closeandlockclasp.(g.10)
STEP 4:Adjustforpropertbypullingonstrapuntilyoucant
twongersinbetweenyourdog’sneckandthecollar.(g.11)
STEP 5:Letyourdogweartheproductforsucienttime
conrmingthattheyaremovingaroundnormally.Thisstepisto
ensurethatunderdailyactivitythecollarwillremainsecureand
notbecomeloose.
gure 10