advanced remote trainer STATIC INSTRUCTION Manual
IMPORTANT SAFEGUARDS • This device should only be used when training dogs for deterring unwanted behaviors. • This device is not a toy; keep out of reach of children. • This device is not intended to provide protection against aggressive dogs. • This basic remote trainer should only be used on one dog at a time. • Your dog should be in good health when using this product. • This product is not to be used on dogs less than 9 lbs. • This product is not to be used on dogs less than 6 months old.
Product Overview: Collar INDICATOR LIGHTS: • Low • Med • High MAIN CONTROL BUTTON: Solid Green: Correction level selected and functioning properly • On/Off • C orrection level adjustment • System reset Flashing Green: Correction administered and received All 3 Flashing Red: Low battery STAINLESS STEEL PROBES: Correction administering system BATTERY DOOR: Located on bottom of unit for battery installation and removal FABRIC COLLAR ADJUSTABLE BUCKLE EXTERNAL ANTENNA QUICK RELEASE CLASP 2
Product Overview: Remote Control INDICATOR LIGHTS: POWER INDICATOR LIGHTS: TRANSMIT Solid Green: Remote is on Flashing Green: The warning or correction has been transmitted effectively Flashing Red: Over Correction Mode Flashing Red: Low battery • Correction button • On/Off • Warning tone button BATTERY DOOR: Located on the back of remote control for battery installation and removal WRIST LANYARD: To prevent the remote from being dropped 3
How it Works: The Sunbeam® Advanced Remote Trainer should be used as a training aid for you and your pet. This specially designed system will shut off if there is an excess of corrections, for example, if something is leaning on the correction button or if there is continuous pressing. This is called Over Correction Mode and will cause the unit to turn off and automatically reset. IMPORTANT: The Sunbeam® Advanced Remote Trainer has a range of up to 150 yards.
The unit will beep twice and flash twice leaving no LEDs illuminated indicating the unit is off. • When replacing batteries after usage you must completely discharge the collar by holding a plastic handle screwdriver across both stainless steel probes for 5 seconds. Make sure the metal portion of the screwdriver is touching both stainless steel probes and the unit is in the OFF position. Remote Control Battery Installation: • Remove the battery door from back of the remote control.
Make sure the metal portion of the screwdriver is touching both stainless steel probes and the unit is in the OFF position. Trimming the hair around the dog’s neck where the stainless steel probes will touch the skin is optional, DO NOT trim the hair so short that the skin is completely exposed as this might allow for an irritation or rash to occur. Use a wrench when assembling or disassembling the stainless steel probes, do not over tighten. (fig. 8) STEP 3: Close and lock clasp. (fig.
When a green LED is illuminated press the Main Control Button once to toggle to the next correction level. Once a correction level is chosen all 3 green LEDs will illuminate every 10 seconds to advise the unit is on. IMPORTANT: Always make sure to turn off the collar when not in use to conserve battery life. Note: It is recommended to start on the LOW setting and monitor your dog’s behavior before determining if a higher correction level is needed.
SPECIAL OPERATING NOTES REMOTE CONTROL: For precaution, the collar will be ready to use 10 seconds after the user has selected or made adjustments to the correction level on the collar. The collar will not react to the handheld remote when the user turns the collar on and/or toggles the correction settings during this period. WARNING BUTTON: If the user presses the warning button on the remote control, the transmit green LED on the remote will flash. There will be an audible beep at the collar unit.
of an extreme reaction or aggression, wait until your dog is calm before approaching your dog. The remote trainer should be used when you want to deter unwanted behavior. Do not leave the remote trainer collar on your dog when you are not present. Consistently using the remote trainer at the right time will give you the best results. The more disciplined you are when using the remote trainer the better your dog will understand that unwanted behaviors are not acceptable.
FCC STATEMENT Potential for Radio/Television Interference This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.” Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
DO NOT attempt to repair or adjust any electrical or mechanical functions on this product. Doing so will void this warranty. This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. JCS dealers, service centers, or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and conditions of this warranty.
