Eco Jet Multipurpose Hand-held Steam Cleaner Instruction Booklet SC4500

8
Using your Eco Jet
Before first use
Remove any packaging or marketing materials
that may be attached to the Eco Jet.
Partially fill and then empty the water tank to
remove any foreign particles that may remain
in the tank following the manufacturing
process.
Note: When turned on for the first time, your
new Eco Jet may drip a small amount of
water when initially producing steam. This is
normal and will not reoccur.
Filling the Eco Jet with water
Before filling with water, ensure that the
power cord is removed from the power
outlet.
1. Position the unit on a stable surface and
remove the water tank cap.
2. Slowly fill with 300ml of clean tap water
using the jug and funnel provided. Measure
using the 150ml mark on the side of the
measuring jug. Repeat.
3. Replace the cap and tighten.
Note: Do not exceed the maximum water
level (300ml) as the unit may fail to operate
effectively. The tank may overflow and boiling
water may be emitted from the nozzle instead
of steam.
Using the Eco Jet
Ensure the unit is unplugged from the power
outlet before fitting or changing attachments.
1. Fit the desired attachment following the
instructions on page 9.
2. Insert the plug into a 230/240V power
outlet and turn the power on. The light
near the base of the unit will illuminate,
indicating that the steam boiler is heating.
Once the light goes out (approx. 3 - 4
minutes), the Eco Jet has reached the
optimum temperature for producing steam
and is ready to use.
3. Direct the Eco Jet at the desired surface
and depress the steam trigger on the
handle.
4. Slowly move the Eco Jet back and forth
over the surface to be cleaned. To remove
stubborn stains, hold the unit over the area
for several seconds.
5. Once you have finished cleaning the
desired area remove the plug from the
power outlet.
6. Allow the unit to cool completely before
storing.
Caution: Do not tilt the Eco Jet more than 45
degrees from the horizontal or turn it upside
down during or immediately after use. Boiling
water could come out of the nozzle instead of
steam.
Filling the Eco Jet during use
Do not unscrew the water tank cap until the
following steps have been followed.
1. Unplug the power cord form the outlet.
2. Remove any remaining steam from the
water tank by depressing the steam trigger
until the tank is completely empty.
3. Partially unscrew the water tank cap,
waiting five minutes for any remaining
steam to escape and to allow the unit to
cool down. Proceed to completely unscrew
the cap.
4. Carefully empty any remaining water from
the water tank.
Caution: Water will be extermely hot.
Note: Always ensure that the water tank is
completely empty before refilling the Eco
Jet to avoid overfilling. Do not exceed the
maximum water level.
5. Slowly refill with 300ml (max) of clean tap
water using the jug and funnel provided.
Measure using the 150ml mark on the side
of the measuring jug. Repeat.
6. Replace the cap and tighten.