User’s Manual 5,850 BTU Room Air Conditioner Model: SCA062RWB1 20060316
Table of Contents Page Introduction 2 Parts Identification 2 Electrical Specifications 4 Tips Before Installation 5 Installation Instructions 6 Operating Instructions 9 Care and Maintenance 13 Troubleshooting Guide 14 1
Introduction Thank you for choosing this room air conditioner to cool your home. This USE AND CARE MANUAL provides information necessary for the proper care and maintenance of your new room air conditioner. If properly maintained, your air conditioner will give you many years of trouble free operation. To avoid installation difficulties, read instructions completely before starting. This manual contains information for the installation and operation of your room air conditioner.
Introduction Part Identification Remote control model Horizontal Air Vane Vertical Air Vane Interior Air Outlet Fresh Air Lever (for 8K model only) Cabinet Air Filter(Inside) Front Panel Exterior Air Inlet Interior Air Inlet Grille Timer Fan Mode Airc ond ition er Remote Control Control Panel Power Cord Control Panel Remote Control Power Timer Mode Power Saver Auto Fan Speed High Mid Low _ + Temp/Time Timer Fan Speed Mode Airconditioner Note: The figures in this manual are base
Electrical specifications 1. All wiring must comply with local and national electrical codes and must be installed by a licensed electrician. Once you have any questions regarding the following instructions, contact a licensed electrician. Electric Shock Hazard If the air conditioner has a serial plate rating of 115 volts and up to and including 7.5 amps the unit maybe on a fuse or circuit breaker with other devices.
Tips before installation Your Room Air Conditioner unit is designed to be highly efficient and save energy. Follow these recommendations for greater efficiency. Your Room Air Conditioner was designed for easy installation in a single or double-hung window. NOTE: This unit is NOT designed for vertical (slider type) windows. 1. Select thermostat setting that suits your comfort needs and leave the thermostat at that chosen setting.
Installation instructions ! CAUTION ! Because the compressor is located on the controls side of the unit (right side), this side will be heavier and more awkward to manipulate. Inadequate support on control side of the unit can result in personal injury and damage to your unit and property. Therefore, it is recommended to have someone assist you during the installation of this unit. 1. Select the Best Location A. Your room air conditioner was designed to fit easily into a single or double hung window.
Installation instructions Window installation step 14'' Min 1. If your air conditioner cabinet 18'' wide, it will fit window openings 21'' to 32'' in wide. Minimum opening height is 14'' from bottom of sash to sill (Fig. 1). 21'' to 32'' Fig. 1 2. Insert the guide panels into the guides of the air conditioner. Fasten the curtains to the unit with screws (Fig. 2). 2/5 '' Screws Fig. 2 3. Cut the adhesive-backed seal strip the window width.
Installation instructions Inner Sill Outer Sill 5. Install the L brackets on the outer sill with the short side of the bracket against the back of the inner sill. Install one L bracket 7.5 to each side of center line. See Fig. 5. Center Line 3/4'' Screw 3/4'' Screw Bracket Short Side 6. Carefully lift the air conditioner and slide it into the open window. Make sure the bottom guide of the air conditioner drops into the notches of the L brackets.
Operating Instructions Mechanical control model MODE The mode knob controls fan speeds and cooling speeds. To set desired cooling temperature, simply rotate the mode knob dial to the appropriate setting. See Fig. 9. Thermostat knob Mode knob THERMOSTAT The thermostat automatically controls the cooling cycle (compressor) of the air conditioner to maintain room temperature. However, the fan motor will continue to operate after the compressor (cooling cycle) is completed. See Fig.9. Fig.
Operating Instructions Control Panel You can easily operate this air conditioner by pressing relevant button on the control panel as well as the remote control. Control Panel Button The air conditioner will be started when it is energized or will be stopped when it is in operation, if you press this button. When the air conditioner is heating, allow 3 minutes after you press this button.
Operating Instructions Remote control 1 Power BUTTON 1 Power Timer Mode Power Saver 2 7 Auto 4 3 Fan Speed High Mid The appliance will be started when it is energized or will be stopped when it is in operation, if you press this button. 8 9 2 5 3 Used to select the operation mode. BUTTONS Used to set room temperature in COOLING mode or used to set time in Timer mode. 6 Low _ Mode BUTTON 4 + Temp/Time High BUTTON Used to select the high fan speed mode.
Operating Instructions Remote control How to Insert the Batteries Remove the battery cover according to the arrow direction. Insert new batteries making sure that the (+) and (-) of battery are matched correctly. Reattach the cover by sliding it back into position. Note: Use 2 LR6 AA(1.5volt) batteries. Do not use rechargeable batteries. Replace batteries with new ones of the same type when the display becomes dim. If the replacement is done within 1 minute, the remote control will keep original presetting.
Care and Maintenance When servicing the air conditioner, be sure to turn the mode switch to the "OFF" position and disconnect the power cord from the electrical outlet. 1. DO NOT use gasoline, benzine, thinner or other chemicals on the air conditioner as these substances may cause damage to the paint finish and deformation of plastic parts. ! CAUTION ! DO NOT forget to install the air filter.
Troubleshooting Guide Frequently, a problem is minor and a service call may not be necessary, use this troubleshooting guide for a possible solution. PROBLEM Air conditioner will not operate POSSIBLE CAUSE No power to the unit. SUGGESTED SOLUTION Check connection of power cord to power source. Check fuse or circuit breaker. Set MODE knob to position other than "OFF". Inefficient or no cooling Dirty air filter. Clean or replace air filter. Inappropriate capacity for application.
© 2006 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Sunbeam® is a registered trademark of Sunbeam Products, Inc. used under license. Distributed by Petters Consumer Brands, LLC. 4400 Baker Road, Minnetonka, MN 55343. For service, support and warranty information, visit www.sunbeammajorappliances.com or in the US call 1-866-866-6283.
