Owner Manual
Assembly
Standard 20 lb. tank
7
7
B
A
7. Connect Gas Tank
(I) Connect hose and regulator to cylinder. See Figure A.
(II) Turn the cylinder valve clockwise to close the gas supply on the gas
cylinder. Screw the regulator coupling clockwise by hand only.
Make sure it is fastened. See Figure B.
The propane gas and cylinder are sold separately. Use a standard 20 lb. propane cylinder only. Use this re table only
with a vapor withdrawal supply system. See Chapter 3 of the standard for storage and handling of liqueed petroleum
gas, ANSA/NFPA 58. Your local library or re department should have this book.
Storage of an appliance indoors is permissible only if the cylinder is disconnected and removed from the appliance.
A cylinder must be stored outdoors in a well-ventilated area out of reach of children. A disconnected cylinder must have
all dust caps tightly installed and must no be stored in a building, garage or any other enclosed area.
The maximum inlet gas supply pressure: 250 PSI. The minimum inlet gas supply pressure: 5 PSI.
The pressure regulator and hose supplied with the appliance must be used. The installation must
conform with local codes or in the absence of local codes, with national fuel gas code,
ANSI Z223.1/NFPA54, NFPA58, natural gas and propane Installation Code, CSA B1491.1, or
propane storage and handling code, B149.2.
A dented, rusted or damaged propane cylinder may be hazardous and should be checked by your
cylinder supplier. Never use a propane cylinder with a damaged valve connection.
The propane cylinder must be constructed and marked in accordance with the specications for
LP gas cylinders of the U.S. Department of Transportation (DOT) or the standard for cylinders,
spheres and tubes for transportation of dangerous goods and commission, CAN/CSA-B339.
The cylinder must have a listed overlling prevention device.
The cylinder must have a connection device compatible with the connection for the appliance.
The cylinder used must include a collar to protect the cylinder valve.
Never connect an unregulated propane cylinder to the appliance.
8. Install Cylinder. Put the cylinder into bottom Plate (E) and secure the
cylinder by tightening the screw in the bottom plate.
8
1-877-387-3639 | Page 13