Owner Manual

Assembly
Page 8
3. Attach the Table Top (A) to the assembled side panels. Align the holes
in the Table Top (A) with the holes at the top of the Back Panel (B) and
Door Panel with Door (F) and insert M8x16 Bolts through M8 Washer
(EE) and through holes. Tighten with Wrench B (GG). Align the holes in
the control box with the holes at the left side panel, insert M8x10 Bolt,
tighten the Bolt.
DO NOT OVERTIGHTEN as you will need to adjust the holes to ensure
proper alignment.
DD M8x16 Bolt x 4
Washer x 4
EE
M8x10 Bolt x 1
HH
Hardware Used:
Note: The Control box on the
burner Assembly should face
towards the D panel with a hole.
To ensure the control box and
the left side panel align, adjust
the two screws to atteched table
top and control box.
After completely assembling the
re table, please tighten all the
screws on the re table.
5
9
7.5”
Blue
Light Blue
Yellow
Good Flame
Blue
Light Blue
Yellow
Bad Flame
3
To continue assembly refer to page 12.
Natural Gas Conversion
Natural gas conversion must be performed only by a natural
gas provider or service company.
Refer to pages 9 - 11 for more information.
High Altitude Conversion
For installations above 2,000 feet, contact your local dealer or gas supplier
before installing as input ratings will be reduced approximately 4% for each
1,000 feet above sea level. Refer to the National Fuel Gas Code.
*High Altitude Conversion Kit
Contact your distributor to obtain a High Altitude Conversion Kit.
Conversion kit includes the proper orice, conversion diagram and
conversion label.
Refer to pages 9 - 11 for more information.