Convection Panel Heater 2200 Watt Instruction Booklet HE4200 Please read these instructions carefully and retain for future reference.
Contents Sunbeam’s Safety Precautions 2 Safety precautions for your Heater 3 Features of your Convection Panel Heater 4 Using your Convection Panel Heater 6 To attach the feet with wheels 7 Troubleshooting Guide 8 Care and Cleaning 8 Important instructions – retain for future use.
Sunbeam’s Safety Precautions • • • • • • • • Sunbeam is very safety conscious when designing and manufacturing consumer products, but it is essential that the product user also exercise care when using an electrical appliance. Listed below are precautions which are essential for the safe use of an electrical appliance: Read carefully and save all the instructions provided with an appliance. Always turn the power off at the power outlet before you insert or remove a plug.
Safety Precautions For Your Heater • • • • • • SAFETY PRECAUTIONS FOR YOUR SUNBEAM Convection PANEL heater. This heater becomes hot during use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 1metre away from the front of the heater and keep them away from the sides and rear.
Features of your Sunbeam Convection Panel Heater Slimline Design Pressed metal exterior Solid stable feet Wheels for easy maneuverability 4
Thermostat controlled operation 2 Heat and off setting Thermostat indicator light 5
Using your Sunbeam Convection Panel Heater 1. Place the heater on a flat level surface. Ensure that the heater is at least 1 metre away from furniture and curtains. 2. Insert the plug into a 230-240 power outlet. Turn the power on. 3. Press the switch to either LOW or HIGH setting. 4. To achieve your desired room temperature use the Thermostat Control dial which adjusts the temperature. 5. To turn off your heater, switch your heat setting button to the 0 position. 6 6.
To attach the feet with wheels The HE4200 has the feet with wheels and screws stored within the box, separate to the body. Mounting Screw holes Locating slots Positioning is only possible in the one orientation, either foot can be used at either end. Attaching the feet with wheels 1. Carefully position the heater upside down on a carpeted area. 2. Use the screws provided to fix the feet with wheels to the body at either end of the heater using a screwdriver.
Troubleshooting Guide 1. If your heater fails to operate, check the following: - Make sure the electrical outlet or circuit breaker is working.. - Check that the thermostat is not set too low. Turn the dial clockwise to adjust the electric thermostat. Until the heater restarts. - Check for obstructions, if obstructions are present, the heater may have gone over temperature.
2 Year Replacement Guarantee In the unlikely event that this appliance develops any malfunction within 2 years of purchase (3 months commercial use) due to faulty materials or manufacture, we will replace it for you free of charge. Should you experience any difficulties with your appliance, please phone our customer service line for advice on 1300 881 861 in Australia, or 0800 786 232 in New Zealand. Alternatively, you can send a written claim to Sunbeam at the address listed below.
Need help with your appliance? Contact our customer service team or visit our website for information and tips on getting the most from your appliance. In Australia Visit www.sunbeam.com.au Or call 1300 881 861 In New Zealand Visit www.sunbeam.co.nz Or call 0800 786 232 is a registered trademark. Made in China. Due to minor changes in design or otherwise, the product may differ from the one shown in this leaflet. © Copyright. Sunbeam Corporation Limited 2011.