SB-WM-F-L-BL / SB-WM-T-L-BL Weatherproof Universal Fixed and Tilt Mounts for Large Displays Install Guide
Warnings Installation by a qualified professional is highly recommended for this product. Do not begin installation until you have thoroughly read and understand these instructions. This mount supports displays up to VESA 700×500, and a maximum load of 165 lbs (75 kg). Ensure the wall can safely support four times the combined weight of the mount and display. The manufacturer does not accept responsibility for incorrect installation.
Installation Caution: Overtightening bolts can damage the bolts and reduce their holding strength. Mount the Wall Bracket Pro Tip: The wall bracket features a screw slot for temporary placement to help mark pilot holes. For Mounting on a Stud Wall Use a stud finder to locate your studs. Drill pilot holes into two wood studs using a 1/4" drill bit. Drill into the center of the studs at least 2-1/2" deep. Insert four lag bolts (U) and washers (V) through the wall plate into the pilot holes and tighten.
Hang the TV on the Wall Plate Carefully lift the TV to hook the arms over the top lip of the wall plate. Allow the lower portion of the arms to swivel in under the bottom lip of the wall plate. Do not release the TV until it is completely seated. Adjustments Forward Tilt Adjustment (SB-WM-T-M-BL only) Using the included long hex wrench, loosen the tilt adjustment locks (circled) on the sides of the arms enough to allow movement. Set the tilt to the desired angle, then tighten the locks.
