Manual
3. Final Assembly
A. Hold the display assembly over the wall plate and slide the mount into the wall plate.
B. To remove, carefully slide the mount upwards and out of the wall plate.
C. For extra security and stability, tighten the set screw located on the wall plate (see illus-
tration to the right) using the included hex key. Remember to loosen the set screw before
attempting to remove the mount form the wall.
D. To use the integrated cable management feature, rst remove the plastic covers located
on the arms of the mount. Route your cables through the arms and re-attach the plastic
covers to hold them in place. Make sure to leave enough slack in the cables so that they
are not pulled or pinched when you move the mount. You may also route the cables
through the hook located at the bottom of the wall plate.
OPERATION AND ADJUSTMENT
• T
o adjust the tilt angle or rotate your screen, firmly grasp the sides of your display and
carefully move it into position. If you find the mount is too difficult to move or is too loose
to hold your TV in position, adjust the three screws located directly behind the head of the
mount using the included security key (see illustration to the right). Tighten the screws
evenly once positioned.
• Swivel adjustments can be made by moving your display into the desired position. The
swivel joints can be adjusted using the included hex key (see illustration to the right).
170912-1106 © 2017 SunBrite
LIFETIME LIMITED WARRANTY
SunBriteTV® Mounts have a Lifetime Limited Warranty. This warranty includes parts on all components found to be defective in
material or workmanship under normal conditions of use. This warranty shall not apply to products which have been abused,
modied or disassembled. Products to be repaired under this warranty must be returned to SunBriteTV or a designated service
center with prior notication and an assigned return authorization (RA) number.
Technical Support 866.838.5052