Installation Guide

13
1
1
3
2
6
V
K
LL
X6
1
3
2
x8
LL
5
K
U
Slide roof ridge beam bracket (S) under tabs on inside
peak of front header (K) and secure with two screws
(LL). DO NOT over tighten screws.
Lay front header (K) on ground with lettering facing up.
Place vent screen (U) into rear opening in front header (K).
Secure through back of header with eight screws (LL).
DO NOT over tighten screws.
1
2
4
x2
K
LL
S
Header Pre-Assembly
Insert header beam (V) into header (K). Attach using six
screws (LL). DO NOT over tighten screws.
Repeat steps 4-6 for rear header (AA).