Installation Guide

18
D
Side viewSide view
Top viewTop view
Before proceeding, make sure
corner is square (top view) where it
meets the floor and that panel is flush
(side view) with floor.
If not, repeat Steps 13–15
until square and flush.
16
JJ
x4
18
Shed Assembly/Walls (continued)
1
2
E
17
Align tabs on bottom of side panel (E) with slots along
front and rear floors. Lower panel into slots and lock in
place by sliding panel toward front corner.
Note: Use a rubber mallet to “push” side panel (E)
into locked position.
Secure side panel with four easy bolts (JJ), working from
floor to roof. DO NOT use torque wrench. Use easy bolt
easy driver (KK) and hand tighten. Easy bolt head will be
flush when fully seated. DO NOT over tighten easy bolts.
Note: You may hear a click when easy bolt has been
tightened completely.