Installation Guide

21
Shed Assembly/Headers (continued)
1
1
3
2
22
x2
LL
x8x8
Slide truss assembly into place. Secure to side panels
with four screws (LL) in each side adapter bracket.
1
3
2
23
EEE
FFF
T
Raise ridge beam (T) up and into rear roof ridge beam
bracket. Secure with one 2" hex bolt (FFF) and one nut
(EEE).
Note: Alignment of ridge beam to bracket may require
header panels to be pushed inwards or outwards slightly
as ridge beam is slid into place.
1
3
2
24
EEE
T
FFF
Slide ridge beam (T) into front roof ridge beam bracket.
Secure with one 2" hex bolt (FFF) and one nut (EEE).
Note: Alignment of ridge beam to bracket may require
header panels to be pushed inwards or outwards slightly
as ridge beam is slid into place.
25
LL
Attach the roof truss assembly to the ridge beam with
one screw (LL).