Instructions / Assembly


1
2
G
23
JJ
x4
22
Align tabs on bottom of back panel (G) with slots along
floor. Lower back panel into slots and lock in place by
sliding panel toward corner.
Note: To allow back panel to overlap left back corner, tilt
out slightly as you slide it into position.
Note: Use a rubber mallet to “push” back panel (G)
into locked position, aligned with left back corner.
-i`ÊÃÃiLÞÉ7>ÃÊVÌÕi`®
-iVÕÀiÊÃ`iÊ«>iÊÜÌÊvÕÀÊi>ÃÞÊLÌÃÊ®]ÊÜÀ}ÊvÀÊ
floor to roof. DO NOT use torque wrench. Use easy bolt
easy driver (KK) and hand tighten. Easy bolt head will be
flush when fully seated. DO NOT over tighten easy bolts.
Note: You may hear a click when easy bolt has been
tightened completely.