Use and Care Manual
20
JJ
x4
24
-iVÕÀiÊL>VÊ«>iÊÜÌÊvÕÀÊi>ÃÞÊLÌÃÊ®°Ê7ÀÊvÀÊ
floor to roof. DO NOT use torque wrench. Use easy bolt
easy driver (KK) and hand tighten. Easy bolt head will
be flush when fully seated. DO NOT over tighten easy
bolts.
Note: You may hear a click when easy bolt has been
tightened completely.
1
2
H
25
Align tabs on bottom left side of right back corner (H) with
slots along floor. Lower panel into slots and lock in place by
sliding panel toward back panel.
Note: To allow right back corner to overlap back panel,
tilt out slightly as you slide it into position.
Note: Use a rubber mallet to “push” right back
corner (H) into locked position, align with previously
installed back panel.
-i`ÊÃÃiLÞÉ7>ÃÊVÌÕi`®