Installation Guide

14
Pre-Assembly - Door
Remove protective wrapping and separate door windows (R).
Separate the two window gaskets (P) and peel off backing.
1
R
R
1
2
2
x13
NN
P
K
R
At bottom interior side of left door (J), attach D-ring slide bolt (O)
with four screws (DDD) through provided holes.
1
2
4
x4
O
J
DDD
At top interior side of left door (J), attach D-ring slide
bolt (O) with four screws (DDD) through provided holes.
1
2
3
x4x4
DDD
O
J
Power tools can apply excessive torque resulting in damage to the product. If you choose to use a power drill to assemble
the product, Suncast recommends using a variable speed, cordless drill with a variable clutch set at the lowest setting. A #2
Phillips driver bit is compatible with the hardware provided. Suncast makes no guarantee that following this recommendation
will prevent damage to the product. Damage to parts due to over-torque are not covered under Suncast’s limited-warranty.
This item uses self-tapping screws in some areas. There are no pre-drilled holes. Use force when starting to drive the screw.
Once the screw pierces the plastic it will drive easier.
Place right door (K) on flat surface, facing down. Starting at the
top-center of the window, press one end of the gasket (P) into the
channel and work around the window. DO NOT STRETCH GASKET.
Trim any excess gasket with scissors.
Lay one door window (R) over the window opening. Secure window
with 13 screws (NN).
Repeat for left door (J) and remaining door window (R).