Installation Guide

3
Before You Begin...
• Consult your local authorities for any permits required to construct shed.
Prior to the construction of your shed, check with the local building code official to review any required permits
or building limitations.
• A level and sturdy foundation is required before shed construction can begin.
Site preparation information is available later in this manual. A foundation that differs from the suggestions
within this manual could prevent proper assembly and may damage parts.
• Read instructions thoroughly prior to assembly.
This kit contains parts that can be damaged if assembled incorrectly or in the wrong sequence.
• Please follow instructions.
Suncast is not responsible for replacing parts lost or damaged due to incorrect assembly.
• Assistance is required during entire assembly.
Indicates at least 1 additional adult is needed to complete this step.
Indicates caution is recommended when using a power drill.
IMPORTANT
COMPLETE SITE PREPARATION AND FOUNDATION CONSTRUCTION BEFORE UNPACKING ALL PARTS.
OPEN ALL BOXES FIRST AND NEATLY LAYOUT PARTS. SMALL PARTS MAY BE CONTAINED IN EACH BOX. PLEASE
REFERENCE THE PARTS LIST WITHIN THIS MANUAL TO VERIFY ALL PARTS ARE PRESENT.
Caution
• Power tools can apply excessive torque resulting in damage to the product. If you choose to use a
power drill to assemble the product, Suncast recommends using a variable speed, cordless drill with a
variable clutch set at the lowest setting. A #2 Phillips driver bit is compatible with the hardware provided.
Suncast makes no guarantee that following this recommendation will prevent damage to the product.
Damage to parts due to over-torque are not covered under Suncast’s limited-warranty.
• Proper site preparation required.
• Shed not intended for storage of flammable, caustic or corrosive materials.
• Shed not intended for habitation of use by children.
• DO NOT stand, sit, or store items on storage shed roof.
• Repair or replace broken parts immediately.
• Hot items, such as recently used grills, blowtorches, etc., must not be stored in the shed.
• Heavy articles should not be leaned against the walls, as this may cause panel distortion and
permanent damage.
• Suncast is not responsible for damage caused by weather or misuse.
• This kit contains parts with metal edges. Please be careful when handling.
• WHEN DRILLING THROUGH METAL, beware of burrs, shavings and other sharp edges.
Safety glasses are stongly recommended.