User's Manual

position.
4. Secure the MOTOR CLIP WITH SET SCREW with the SCREWDRIVER, which is
stored at the bottom of the CONTROLLER. Plug the TRANSFER GEAR into the axle
as shown. (illus)
Caution: Do not overtighten the SET SCREW. (illus)
5. Plug the HUBCAPS into the REAR AXLE GEAR, and press the TIRES over the
HUBCAPS. Next, secure the REAR AXLE GEAR assembly into the CHASSIS as
shown. (illus)
6. Plug the LED connector of the car top into the car chassis’ male connector as
shown.
7. Thread the ANTENNA through the hole in the BODY TOPS. Snap the BODY TOP to
the back of the CHASSIS, then secure the front by gently pushing the BODY TOP
onto the CHASSIS as shown. (illus)
8. Zip Tips
• If your micro RC’s motor runs or your car responds erratically or sluggishly
• move closer to your micro RC, b) be sure your hand is not touching the
CONTROLLER’S antenna, or c) check the batteries.
• If your micro RC moves slowly, or not at all, and you just charged or recharged
it, check the wheel mechanisms for lint, thread, hair, or dust. Also, make sure
the axle gear meshes correctly with the transfer gear.
• You may not be able to operate your micro RC near devices that use the same
frequency. Check your CONTROLLER to see which frequency you use. You
may need to play with your micro RC in another location.
• CBs could interfere with control of the micro RC. If this happens, move the
micro RC away from the CB.
• When speed, range, or steering response from your micro RC decreases,
recharge your micro RC.
• To lengthen the operating time of your battery, unplug the lights Connector.
The lights draw power away from the motor as battery power decreases.
• Keep your ZipZaps micro RC dry. If it gets wet, wipe it dry immediately.
• Use and store your micro RC Monster Truck only in room-temperature
environments.
• Handle your micro RC carefully and don’t drop it.
• Keep your micro RC away from dust and dirt. You can wipe it with a damp
cloth occasionally.
• Modifying or tampering with your ZipZaps micro RC internal components can