User's Manual

ManualsBrandsSuncon Toys Industry ManualsToys & GamesR/C TOY RECEIVER

It’s the ultimate radio-control experience! Your Starter Kit comes with a radio controller and a

ZipZaps micro RC with all factory parts. All parts are pre-assembled, race your ZipZaps just

out of the package with a quick charge of about 60 seconds.

. Light up the race track with your ZipZaps headlights.

. Carry your 1:64 scales tunable ZipZaps in your pocket.

. ZipZaps provide great fun for ages 8 and up.

To really rev up the fun factor, customize your ZipZaps micro RC with optional performance

upgrade kits, viewable at the ZipZaps Showroom at www.zipzaps.com and available at your

local RadioShack.

Follow these simple steps to make your ZipZaps race ready.

1. Starter Kit Includes

Your ZipZaps micro RC Starter Kit includes everything you see here.

All parts are pre-assembled and ready to race for your quickest fun.

Controller (illus)

Tires (illus)

Hubcaps (illus)

Body Top (illus)

Chassis (illus)

Motor clip with set screw (illus)

Performance motor with drive gear (illus)

Transfer gear (illus)

Screwdriver (illus)

Rear axle gear (illus)

Wrist strap (illus)

2. Power Up Your Controller

The CONTROLLER charges your micro RC and controls its steering and speed. You’ll need to

install four AAA 1.5V batteries (not included). The ZipZaps factory recommends RadioShack

Enercell Plus alkaline batteries.

1. Set ON/OFF on the CONTROLLER to OFF.

2. Use the SCREWDRIVER stored at the bottom of the CONTROLLER to loosen the

screw and remove the battery compartment cover. (illus)

3. Place four AAA 1.5V batteries in the compartment according to the polarity symbols (+

Summary of content (6 pages)

PAGE 1
It’s the ultimate radio-control experience! Your Starter Kit comes with a radio controller and a ZipZaps micro RC with all factory parts. All parts are pre-assembled, race your ZipZaps just out of the package with a quick charge of about 60 seconds. . Light up the race track with your ZipZaps headlights. . Carry your 1:64 scales tunable ZipZaps in your pocket. . ZipZaps provide great fun for ages 8 and up.
PAGE 2
and -) marked inside. (illus) 4. Replace the cover and secure it with the screw. If you notice the range of your CONTROLLER decreasing, it is time to replace the batteries. Battery Notes - Use only fresh batteries of the required size and recommended type. - Do not mix old and new batteries, different types of batteries (standard, alkaline or rechargeable) or rechargeable batteries of different capacities.
PAGE 3
Warning: Do not run your micro RC in the street. Open the removable cover on top of the CONTROLLER. Fully extend the antenna. (illus) Set ON/OFF on the CONTROLLER to ON. The ON/OFF indicator lights green. Steering: Use the CONTROLLER buttons to drive and steer. Left Control Button (illustration) . Press forward to move forward . Release to stop . Press backward to move backward Right control Button (illustration) . Press left to turn left . Release to go straight .
PAGE 4
position. 4. Secure the MOTOR CLIP WITH SET SCREW with the SCREWDRIVER, which is stored at the bottom of the CONTROLLER. Plug the TRANSFER GEAR into the axle as shown. (illus) Caution: Do not overtighten the SET SCREW. (illus) 5. Plug the HUBCAPS into the REAR AXLE GEAR, and press the TIRES over the HUBCAPS. Next, secure the REAR AXLE GEAR assembly into the CHASSIS as shown. (illus) 6. Plug the LED connector of the car top into the car chassis’ male connector as shown. 7.
PAGE 5
cause a malfunction, and might invalidate its warranty, and void your FCC authorization to operate it. 9. Performance Tune Customize your ZipZaps micro RC with performance, body, and power upgrade kits, available at your nearby RadioShack. The charts (Performance Gears chart & Performance Motors chart) will give you an idea of what a little performance tuning can do for your micro RC! Visit the ZipZaps Showroom at www.zipzaps.com and your local RadioShack.
PAGE 6
04/04