User's Manual

3.9 Intercom
3.9.1 Internal call
• Press KEY_INT
• Enter the number of the internal handset (1 to 5)
The
and “INT” icons displayed, the number of the internal handset display “INT” with caller
handset number and rings (INT MEL).
Remark: the caller handset go to standby mode if the number of the internal handset is not
available or caller handset
3.9.2 End of intercom call
Incoming call applied then go to ring in mode.
The number of the internal handset press KEY_HOOK go to INTERCOM mode
3.9.3 Intercom mode
The
and “INT” icons displayed on both handsets.
3.9.4 End of intercom
Any handset (intercom) press KEY_HOOK, go to standby mode
Incoming call applied then go to ring in mode.
3.10 Page button
Press Page button on the base.
The handsets will ring RING_1 at volume of Handset internal ring level setting and display INT with
“□□□□”during 30s unless page key is pressed again on the base or a key is pressed on any locked
handset. (When the handset set to key lock, user can be stop the paging by pressing any key)
3.11 Battery and charge management
3.11.1 Battery indicator
5 levels indicators icon for mean battery voltage:
> = EEP_BAT_FULL_LEVEL
> = EEP_BAT_HALF3_LEVEL
> = EEP_BAT_HALF2_LEVEL,
Blinking > = EEP_BAT_ALARM_LEVEL
3.11.2 Low battery conditions
If the following conditions are applied:
During a call,
• If mean battery level is less than EEP_BAT_HALF1_LEVEL,
13 of 25