User's Manual
Table Of Contents
- USER_MENU.pdf
- USER_MENU.pdf
- Handset description
- Base description
- Main User interface
- Call User interface
- MENU Settings
- Prefix dialling
- Quick default settings
- Subscribe a new handset
- Test modes
- Specifications
- USER_MENU.pdf
4.2.1 BASE VOL
This menu enables you to adjust base ring volume
• Select "BASE VOLUME" and validate
• Select the desired volume (VOLUME OFF or VOLUME 1 to 5) and validate
4.2.2 BASE MEL
This menu enables you to select base ring melody
• Select "BASE MELODY" and validate
• Select the melody of your choice (1 to 5) and validate
4.2.3 DEL HS
You can cancel a handset’s association with a base to allow another handset to be associated
• Select "DEL HANDSET" and validate
• Enter the PIN code and validate
• Select the handset to be cancelled and validate
4.2.4 PIN CODE
The base PIN code is used in subscription operation or to modify some critical parameters in the base.
To change the PIN code:
• Select "PIN CODE" and validate
• Enter the old 4 figure confidential code and validate
• Enter the new 4 figure confidential code and validate
• Enter the new confidential code a second time and validate
4.2.5 Dial mode selection (This mode will not appear when set the Pulse dialling disable by
EEPROM
Two types of dialling are available:
1. DTMF tone dialling
2. Pulse dialling
To change the dialling mode:
• Select “DIALMODE” and validate
• Select “TONE” or “PULSE” of dial mode and validate
FTXX_DIAL_MODI : selected by EEPROM data
Note: the Dial mode selection menu can be hidden to lock the base into pulse or DTMF dialling by the
CONFIG_ENA_MENU_DIALMODE flag (see various factory settings).
4.2.6 Recall duration selection
• Select "RECALL"
• Choose RECALL 1 to select short flash time
• Choose RECALL 2 to select long flash time
RECALL 1 & 2 timing : selected by EEPROM data
Note: not recall select function in if RECALL 1 & RECALL 2 is same timing.
4.2.7 Default settings
This menu enables you to reset both handset and base with default settings.
By SET UP menu,
• Select "DEFAULT"
• Enter the base PIN code and validate
• "CONFIRM ?" appears, press KEY_OK to confirm
By quick default,
19 of 25