User's Manual

48
Additional Handsets and Bases
R0
Information
You can create phonebook
entries and adjust some
handset settings such as
ringer melody and volume
on an unregistered handset
or out of range handset.
IMPORTANT
Before registration, make
sure the handset batteries
are fully charged and that
you are close to the base.
BASE REGISTRATION
Information
After a handset is registered
with a base, the handset
reverts to standby and is
given the first available
handset number. You can
now use the handset. The
handset number is
determined by the base so
you cannot change it.
Information
All the bases that a
handset can be linked to
are indicated by a
.
Additional Handsets and
Bases
Expanding your system is easy.
Up to four handsets can be registered and
operated from the WDCT45-A2. You can make
internal calls between two handsets while
third is making an external call. Each
handset can be registered on up to four
bases. If you buy new handsets to use with
your WDCT45-A2 they will have to be registered
to the base before you can use them.
Register a new WDCT45-A2 handset
On the base:
1. Press and hold
(page button on
the base) until you hear the base beep.
On the handset
:
2. Press Menu, then scroll down to
Registration and press OK.
3. Register Handset is highlighted.
Press OK.
4. Scroll
or to select the base.
Press OK.
5. Enter the base’s SYSTEM PIN (original
setting 0000). Press OK.
After a few seconds, the handset screen will
show the base ID number. Press OK to
confirm. The handset screen then shows;
‘Handset Registered’.