User's Manual

Important Instructions & Information 7

Interference Information

Notice: The changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC rules and regulations. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any

interference received, including interference that may cause undesirable operation.

This equipment has been tested and found to comply with the limits for a Class B digit device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by tuning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna (that is, the antenna for radio or television that

is “receiving” the interference).

• Reorient or relocate and increase the separation between the telecommunications

equipment and receiving antenna.

• Connect the telecommunications equipment into an outlet on a circuit different from that

to which the receiving antenna is connected.

If these measures do not eliminate the interference, please consult your dealer or an experienced

radio/television technician for additional suggestions. Also, the Federal Communications

Commission has prepared a helpful booklet, “How To Identify and Resolve Radio/TV Interference

Problems.” This booklet is available from the U.S Government Printing Office, Washington, D.C.

20402. Please specify stock number 004-000-00345-4 when ordering copies.