Instructions / Assembly

ManualsBrandsSuncourt ManualsHeating, Ventilation, and Air ConditioningFlush Fit Register Booster Fan in Brown

Flush Fit Register Booster

http://www.suncourt.com/Flush%20Fit%20Print.html[1/13/2012 1:31:42 PM]

OPERATION INSTRUCTIONS FOR THE FLUSH FIT

READ AND SAVE THESE INSTRUCTIONS

IMPORTANT NOTICE

With the use of any electrical appliance, it is important to observe all basic precautions to

minimize the risk associated with use, such as electrical shock, fire, or injury to persons.

Read these instructions before using your Register Booster.

NEVER EXPOSE YOUR REGISTER BOOSTER TO TEMPERATURES OVER

140°F (60°C)

INSTALLATION

FLOOR REGISTER 4” X 10”

1. Plug the small molded end of the power cord into the top of the Register Booster.

2. Plug the wall transformer end of the power cord into a 120 Volt AC outlet.

3. Follow directions for operation settings before placing in register.

4. Remove floor register and replace with the Register Booster.

WALL REGISTER 4” X 10”

1. Drill (2) holes with a 3/16” drill bit from the bottom side of the Register Booster grille.The

holes should be drilled in the pre-molded location as pictured below.

2. Plug the small molded end of the power cord into the top of the Register Booster.

3. Plug the wall transformer end of the power cord into a 120 Volt AC outlet.

4. Follow directions for operation settings before placing in register.

5. Remove the wall register and replace with the Register Booster.

6. Secure the Register Booster in place.

FLOOR & WALL REGISTER 4” X 12”, 6” X 10” & 6” X 12”

Adapter plate sold separately.

Summary of content (4 pages)

PAGE 1
Flush Fit Register Booster OPERATION INSTRUCTIONS FOR THE FLUSH FIT REGISTER BOOSTER MODEL: HC500 READ AND SAVE THESE INSTRUCTIONS IMPORTANT NOTICE With the use of any electrical appliance, it is important to observe all basic precautions to minimize the risk associated with use, such as electrical shock, fire, or injury to persons. Read these instructions before using your Register Booster. NEVER EXPOSE YOUR REGISTER BOOSTER TO TEMPERATURES OVER 140°F (60°C) INSTALLATION FLOOR REGISTER 4” X 10” 1.
PAGE 2
Flush Fit Register Booster CLEANING AND MAINTENANCE Before cleaning the Register Booster disconnect the power cord from the outlet. Dust may be removed from the exterior surfaces using a soft cloth, the round brush attachment of your vacuum cleaner, or using a cloth that has been lightly moistened with water and a mild, non-abrasive detergent.
PAGE 3
Flush Fit Register Booster dangerous electricity, may cause fire and will void any and all warranty. 1. Set the Function switch to Auto Heat (winter) or Auto Cool (summer). 2. To adjust the fan motor ON/OFF point rotate the Set Point knob in the proper direction for your heating or cooling application until the fan motor switches ON, then slightly turn the control knob in the opposite direction until the fan motor stops. DO NOT FORCE.
PAGE 4
Flush Fit Register Booster does not apply to defects resulting from the alteration, abuse, accidental damage, unauthorized repair, or misuse of the unit. This warranty is given in lieu of all other warranties, guarantees, and conditions on manufacturer’s part, and the manufacturer shall have no tortious or other liability in respect to this Register Booster. Actual product appearance may differ from illustrations.