Instructions / Assembly

ZonePrint
http://www.suncourt.com/ZoneMasterPrint.html[1/16/2012 3:22:55 PM]
hardware normally supplied with the thermostat. Do not
mount the thermostat on an outside wall. Locate the
thermostat approximately 5’ (1.5 m) above the floor and
away from drafts and direct sunlight. DO NOT screw the
thermostat to the wall at this time.
Transformer installation:
IMPORTANT WARNING: Locate the breaker on your
house power panel that controls the 110/120 Volt AC
supply to the wires in the junction box that you selected
to mount the Transformer on. Use a voltage detector,
voltmeter or other suitable instrument to make sure that
all power to that junction box is OFF. Identify an existing
wiring junction box near the location desired. Verify that
the correct wires are available in this box. There needs to
be: Black wire (line or hot), White wire (neutral) and a
Green or bare copper wire (ground). The cover plate of
that junction box must have a “knockout”. This
“knockout” must be removed to make the hole for the
stud of the Transformer to mount through. Thread the
Transformer leads through the hole and securely mount
the Transformer to the cover plate. Tighten the nut snug
only.
WARNING: Over-tightening will break the plastic stud of the Transformer. DO NOT
connect the Transformer wires at this time.
Low voltage wiring:
Refer to the wiring diagram below for electrical connections. It is recommended that you
leave at least 1’ (30 cm) of slack wire at each component wired to ease future servicing.