Instructions / Assembly

ZonePrint
http://www.suncourt.com/ZoneMasterPrint.html[1/16/2012 3:22:55 PM]
1. Run one wire from either Transformer low voltage
terminal to either terminal on the Damper.
2. Run one wire from the other Transformer low voltage
terminal to the terminal marked “R” on the thermostat.
3. Run one wire from the other terminal on the Damper
to the terminal marked “W” on the thermostat.
4. Connect the terminals “W” and “Y” on the thermostat
together with a short piece of wire (jumper).
THE WIRING IS NOT POLARITY SENSITIVE.
CONNECT EITHER SCREW ON TERMINAL
BLOCK OR TRANSFORMER.
The final steps:
Screw the thermostat to the wall. Connect the Transformer 110/120 Volt wires
inside the junction box. See IMPORTANT WARNINGS above!
Connect the GREEN wire from the Transformer to the GREEN or bare copper
wire inside the junction box.
Connect either of the BLACK wires of the Transformer to the WHITE wire
inside the junction box.
Connect the remaining BLACK wire of the Transformer to the BLACK wire
inside the junction box.
Place the cover (with the Transformer mounted to it) on the junction box,
making sure that no wires are pinched between the cover and the junction box.
Now review your installation. If you are positive that everything has been