Manual

ManualsBrandsSunex Tools ManualsToolsSX231P

SX231P-2: Parts Breakdown & Operating Manual 08/20/13

Square Drive Size ......................................... 1/2"

Max. Torque ...................500 Ft. Lbs. (677.9 Nm)

Free Speed ........................................ 7,000 RPM

Length ........................................... 7.4" (188 mm)

Weight ........................................6.2 Lbs. (2.8 kg)

Avg. Air Cons. .....................7.0 cfm (198.2 l/min)

Air Inlet .................................................. 1/4" NPT

Min. Hose Size .......................... 3/8" I.D. (10mm)

Sound Pressure Level ........................... 107 dBA

SX231P-2

1/2" Premium imPact

Wrench W/ 2"anvil

SPECIFICATIONS

READ THIS MANUAL BEFORE

OPERATING TOOL.

ALWAYS WEAR EYE PROTECTION

WHEN OPERATING OR PERFORMING

MAINTENANCE ON THIS TOOL.

ALWAYS WEAR HEARING

PROTECTION WHEN OPERATING

THIS TOOL.

AVOID PROLONGED EXPOSURE

TO VIBRATION

WARNING

Operating Instructions • Warning Information • Parts Break down

Summary of content (5 pages)

PAGE 1
Operating Instructions • Warning Information • Parts Breakdown SX231P-2 1/2" Premium Impact Wrench w/ 2"Anvil WARNING read this manual before operating tool. Always wear eye protection when operating or performing maintenance on this tool. Always wear hearing protection when operating this tool. Avoid prolonged exposure to vibration SPECIFICATIONS Square Drive Size.......................................... 1/2" Max. Torque....................500 Ft. Lbs. (677.9 Nm) Free Speed...........................
PAGE 2
WARNING To reduce the risk of injury, anyone using, repairing, maintaining, or changing accessories on this tool must read and understand these instructions before performing any of these tasks. Always inspect, operate, and maintain this tool in accordance with American National Standards Institute Safety Code of Portable Air Tools (ANSI B186.1) and any other applicable safety codes and regulations. These tools are rated at 90 psi / 6.
PAGE 3
Instruction Manual This product is designed to tighten or loosen threaded fasteners. No other use is permitted. Air Supply Requirements Tool is designed to operate at 90 psi (6.2 bar) at free speed measured at the tool, of clean, dry air. Operating this tool at higher pressures will drastically reduce the tool life and could cause injury. The air inlet thread on this tool is a standard 1/4" NPT. Line pressure should be increased for any unusually long air hose run (over 25 feet).
PAGE 4
SX231P-2 1/2" Premium Impact Wrench w/ 2"Anvil REF. PART NO. NO.
PAGE 5
For a complete listing of Authorized Master Repair Centers, visit www. sunextools.com. Limited Warranty... SUNEX INTERNATIONAL, INC. WARRANTS TO ITS CUSTOMERS THAT THE COMPANY’S SUNEX TOOLS® BRANDED PRODUCTS ARE FREE FROM DEFECTS IN WORKMANSHIP AND MATERIALS. Sunex International, Inc.