Switch User Manual

Chapter 3 General Management of the Switch 3-89
Command-line Interface: Mapping IP Precedence
The following example maps IP Precedence value 1 to COS value 0 on port SNP5
15
,
and then displays all the IP Precedence settings for that port.
MIB Variables Associated With Mapping IP Precedence
15.Mapping specific values for IP Precedence is implemented as an interface configuration command, but any
changes will apply to the all interfaces on the switch.
Console(config)#interface ethernet SNP5
Console(config-if)#map ip precedence 1 cos 0
Console(config-if)#end
Console#show map ip precedence ethernet SNP5
Precedence mapping status: disabled
Port Precedence COS
--------- ---------- ---
SNP5 0 0
SNP5 1 0
SNP5 2 2
SNP5 3 3
SNP5 4 4
SNP5 5 5
SNP5 6 6
SNP5 7 7
Console#
TABLE 3-28 MIB Variables Associated With Mapping IP Precedence
Field Name MIB Variable Access Value Range Default Value
IP Precedence
Value
sun...
priorityMgt.
prioIpPrecTable.
prioIpPrecEntry.
prioIpPrecValue
Not-
accessible
Integer (0-7)
IP Precedence
CoS
sun...
priorityMgt.
prioIpPrecTable.
prioIpPrecEntry.
prioIpPrecCos
Read/write Integer (0-7) one-to-one
mapping