Important Safety Instructions 1. Read Instructions. 2. Keep these Instructions. 3. Heed all Warnings. 4. Follow all Instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 8. Refer all servicing to qualified service personnel.
Introduction Dear Friend: Thank you for purchasing a Sunfire XT-Series Cinema Ribbon loudspeaker. We hope you enjoy it and the music it makes as much as we have enjoyed creating it for you. The unique Cinema Ribbon design is based on years of research into human physiology. As an exclusive XT-Series product, this loudspeaker follows a great heritage of both world-class ribbon loudspeaker designs and industry-leading subwoofer technologies.
Overview The Cinema Ribbons are featurerich, high-tech, but most importantly GREAT SOUNDING loudspeakers. Years of research and decades of experience have gone into these small wonders. CRM-2 CRM-2C Center Channel The Cabinet The Cinema Ribbons feature a carefully designed cabinet that stems from years of research into how the box affects the sound of the loudspeaker.
Rear Panel Features 1 2 3 1. Boundary Compensation Switch This switch compensates for the bass and mid-bass loading that occurs when a loudspeaker is wall-mounted, compared to when it is placed away from a wall. Switch it to the left if your loudspeaker is close to a wall or other large objects that may cause reflections. Switch it to the right if the loudspeaker is placed more out into the room, such as when on a stand.
Loudspeaker Locations The details below show various systems incorporating the loudspeakers, with a subwoofer to handle the low frequency range. Ideally, all of the surround loudspeakers in a home theater system should be of the same make and model, and positioned at similar heights to produce a smooth and continuous soundfield. Ideally, the loudspeakers should be placed no closer than 1 to 3 feet from the rear and side walls.
5.1 Configuration Place each surround loudspeaker an equal distance away from your central listening position, and keep them at least one or two feet above ear level (with you sitting down). 6.1 System With two surround back loudspeakers, set the surround back loudspeakers behind and between the surround loudspeakers. 5.1 System They can be placed behind the listening position, on the rear walls or the side walls.
Subwoofer Location The best location for a single subwoofer can be found by following these steps: 1. Place the subwoofer on your couch or favorite easy-listening chair. 2. You can then either run a calibration (noise) signal through it, or play some of your favorite music samples with heavy bass. 3. 8 Walk around the room, standing in all the positions where you might be able to place the subwoofer. This is usually somewhere close to the corners of the room.
Crossover adjustment We recommend that you set your home theater processor's crossover to 100 Hz, and set the channels that use the Cinema Ribbon loudspeakers to "small.
Specifications Troubleshooting The Cinema Ribbon loudspeakers are designed and built to provide years of trouble-free performance. Most problems that occur can usually be solved by checking your setup, or by making sure all components are fully operational. Design 2-way High Pressure Magnetically Shielded Drive Units HF: Waveguide loaded Neodymium Ribbon LF: Dual 4.5-inch High Back-emf The following information will help you deal with common problems you may experience during normal use.
Limited Warranty Sunfire Corporation is proud of its products which have been built with care using advanced technology and premium component parts. Your unit has been crafted to perform properly for many years. Sunfire Corporation offers the following Warranty to you, the owner of a new Sunfire product: The Sunfire Corporation Warranty for the XT-Series Cinema Ribbon loudspeaker is in effect for FIVE years from the date of original retail purchase.