Installation Guide

12 Volt CRYSTALLINE SOLAR PANELS
PANNEAU SOLAIRE CRYSTALLINE DE 12 Volts
User ’s M an ua l
Ma nu el d e l' ut il is at eu r
Congratulations on your Sunforce Products Purchase. This product is designed to the highest technical specifications and
standards. It will supply years of maintenance free use. Please read these instructions thoroughly prior to installation, then store in
a safe place for future reference. If at any time you are unclear about this product, or require further assistance please do not
hesitate to contact our trained professionals operating the customer support line 1-888-478-6435 or email to
[e-mail]
Specifications:
12 Volt output
Tempered glass panel
Aluminum frame
Fully weatherproof design
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
Warning:
• Avoid electrical hazards when installing, wiring, operating, and maintaining your solar module. The solar module included
generates DC electricity when exposed to sunlight or other light sources.
• For use in 12-Volt systems only
• Observe proper polarity throughout entire power cable wiring route
• Work Safely. Do not wear jewelry when working with electrical or mechanical equipment. Use protective eyewear when working
with batteries or drills. Use extreme caution when on ladders or on a roof.
• Follow all safety precautions of the battery manufacturer. Some batteries can release flammable hydrogen gas. Do not produce
sparks when working in locations where flammable gases or vapors exist. Shield skin and eyes from battery acid. Wash thoroughly
with water if skin or clothing come in contact with acid or any corrosive matter, which may have accumulated, on the battery. Keep
the terminals and casing clean.
• Use of a charge controller is always recommended
• Do not attempt to charge non-rechargeable batteries
• When disconnecting, always disconnect battery last
Connecting Solar Panel to Battery
- It is always recommended to use a solar charge controller.
-
Connecting to a Charge Controller
Please follow these easy installation steps
For Junction Box without wires exposed:
1. Open the junction box on the back of the panel
2. Follow the indicated polarity (+/-)
3. Select the required length of wire
4. Either wrap the wire around the screw terminals or utilize ‘Crimp Connectors’
5. Screw down the screw terminals ensuring a tight clean connection.
For Junction Box with exposed wires:
1. Follow the indicated polarity (+/-)
2. Select required length of wire
3. Connect wires and use either wire nut and/or electrical tape for tight connection
Once you have identified the polarity of your wire:
• Connect Positive wire to the POSITIVE on your Solar Charge Controller
• Connect Negative wire to the NEGATIVE on your Solar Charge Controller
• Wire ‘twist nut caps’ may be required for this connection
Caution: Always double check you have the correct polarity prior to connection to your 12 Volt battery.
• Connect your solar charge controller to your 12 Volt battery again following correct polarity
• Your 12 Volt solar panel will now begin to charge (under full sun)
Maintenance Instructions:
Cleaning of the glass may be performed by the user, by utilizing a clean damp cloth.
Any other maintenance to the unit should be performed by qualified service personnel or contact our experienced customer service
team.
TROUBLESHOOTING:
I am not sure if my panel is functioning?
- Ensure battery is operational. Over time, a battery’s ability to recharge will deteriorate.
- Ensure the distance of the wires is not longer than 30 feet to your solar charge controller and all connections are secure.
- Measure the panel voltage with a voltmeter. The voltage reading should be between 16 to 25 volts in the full sun
Warranty
This product is covered by a 25 year limited warranty of 80% of power output, and must be tested under optimal conditions. This
product is warranted from defects in materials and workmanship for a period of 1 year from date of purchase. This warranty does
not apply in the event of misuse or abuse and or repairs and alterations.