Instructions / Assembly
9. Then, insert the earth anchor driving rod through the cable eye and pull.
10. Finish installing the remaining three earth anchors as described above.
Important:
Although the earth anchor is designed to break through small rocks, if there is a rock or obstruction that is too large,
remove and relocate the anchor. The depth of the anchor is critical to its effectiveness.
Tower Assembly
The tower is assembled in several easy steps. If this is a permanent installation, first dig a trench from the base of the
tower, to where the battery is housed. This will assist in the laying of wire from your turbine to battery bank.
Tower Tube Layout
1. Lay out the six tower tubes on the ground as shown. Leave approximately 6” inches (15 cm) between each tube.