7 AMP SOLAR CHARGE CONTROLLER User’s Manual
7 Amp Solar Charge Controller Maintain 12V batteries in a fully charged state Specifications Cut-in Voltage: Cut-Out Voltage: Max. Load: 13Volts 14.2 Volts 105 Watts/ 7 Amps Installation Connect to Battery: Attach the Solar Charge Controller positive (+) wire to the positive (+) battery terminal. Then connect the Solar Charge Controller negative (-) wire to the negative (-) battery terminal.
GENERAL TESTING PROTOCOL Always test outdoors under optimal sunlight Test Solar Panel for Voltage Connect Voltmeter to the panel separately from the charge controller and observe Open Voltage. Open Voltage can range from 16 Volts to 24 Volts. Test Connection to Charge Controller for Voltage. Reconnect solar panel, and connect to charge controller as per instructions. Measure the Open Circuit Voltage at the battery side of the charge controller.
For more information or technical support Pour plus d’information ou support technique 1-888-478-6435 www.sunforceproducts.com info@sunforceproducts.
