Installation Guide
2
1
2
4
5
3
WARRANTy
This product is covered under a one year limited warranty. Sunforce Products Inc. warrants to the original
purchaser that this product is free from defects in materials and workmanship for the period of one year from
date of purchase. The included battery is not covered under this warranty.
Proof of purchase including date, and explanation of complaint is required for warranty service.
• Your motion light is not a toy. Keep it out of reach of small children.
• Your motion light and solar panel are both weather-resistant.
• You can mount your motion light indoors, but your solar panel must be installed outdoors to receive light from
the sun.
• If using a step ladder, you may require a second person to help install the solar motion light.
• Prior to installation, lay out all components to ensure they correspond to the parts diagram on the cover page.
• Never look directly into the solar motion light when illuminated.
• From time to time, ensure the plug between the solar panel and light is securely connected.
• It is advisable to adjust the angle of the solar panel to optimize the exposure of the sun during the
winter months.
• The solar panel should be cleaned with a damp cotton cloth on a regular basis. This will ensure optimal
performance and battery charging. Periodically, utilize the same technique to clean the lens of the
motion light.
• Never let any abrasive material come into contact with the solar panel.
• 60 white LEDs
• Solar panel with 4.5 m / 15 ft wire
• Adjustable motion sensor
• Adjustable time and distance settings
SAfETy INfORMATION
PRODUcT fEATURES
cARE & MAINTENANcE
Ensure your solar panel is placed so that
its exposure to the sun is optimized.
Be aware of objects such as trees or
property overhangs that may impede the
panel’s ability to generate a charge.
Optional: Use a power drill (not included)
to create the holes on your chosen
mounting surface.
Use 4 of the included wall plugs and
screws to fasten the solar panel to the
surface.
BATTERy REPLAcEMENT INSTRUcTIONS
INSTALLATION
Remove the mounting bracket from the
solar motion light by unscrewing the
side bolts.
Reattach the mounting bracket to the
light and tighten the side bolts (refer to
the illustration in Step 3).
Optional: Use a power drill (not
included) to create the holes on your
chosen mounting surface.
Fasten the mounting bracket to your
chosen surface with the 2 remaining
wall plugs and screws.
When replacing the battery, be sure to:
• Match any replacement battery specications with the removed battery in terms of voltage, size and type.
• Use a rechargeable battery only.
• Observe the correct polarity (+ and -) when installing the replacement battery.