Installation Guide

3
Connect the wire from the solar panel into the socket
located under the light xture. Your solar motion light will
now begin to charge.
Prior to using your solar motion light, the solar panel needs
to be connected to the light for a period of three days. This
initial charge should be done in the OFF position. After the
third day the included battery will be fully charged and your
solar motion light is ready for operation. Place the light in
the AUTO position.
The ON position acts to override the motion activation
function. This will allow a limited period of constant
illumination.
The included lithium-ion battery is located in the battery
housing behind the light xture. Select the OFF position on
the light prior to opening the battery housing. Remove the
four screws to reveal the rechargeable battery.
Your solar motion light requires the use of 1 rechargeable
lithium-ion battery.
ON | OFF | AUTO ON | OFF | AUTO ON | OFF | AUTO
7
6
8
3 different control dials adjust the light’s duration, sensitivity to
light, and sensitivity to motion.
SENS (Sensitivity)
This dial determines the range of motion detection.
TIME (Duration)
This dial sets the duration of illumination time.
LUX (Light level)
This dial tells the sensor the level of darkness that must be
reached before the light turns on.
The sensor will trigger the light to turn on in the daytime.
The sensor will only trigger the light to turn on at dusk or
when it is dark. This is the ideal position for general usage.
MAX MED MIN
9